Dalton Garage Door Openers 3 Button Transmitter 3BTM
Warning! During programming the garage door may
operate. Keep people and objects clear of the moving door to prevent door
damage or possible personal injury.
NOTE: For new transmitter, you must activate its
security code before it can be programmed to the DoorMaster, idrive, Quantum
and Classic drive openers.
NOTE: Activation steps describe the process to
activate a transmitter’s security code.
The following steps describe the process to activate a
transmitter’s security code.
Activating the Transmitter
- Press and hold the large transmitter button. The
red LEDs will blink rapidly.
- After 2 seconds, the red
LEDs will turn on continuously, indicating a successful activation.
Release large button.
- The code for this transmitter has now been
- You must now program this transmitter to the garage
door operator. See “Transmitter Programming.
NOTE: Any of the three transmitter buttons can
be programmed to activate the door. In multi-door installations, each button
or a combination of two buttons pushed at the same time can be programmed to
activate a separate door. Only one button at a time (per-transmitter) can be
programmed to activate a door.
To Program the transmitter:
Place the emergency disconnect in the manual door operated position.
This is for
Press program button on DoorMaster light fixture, idrive, Quantum or
Classic drive powerhead. Led will light or idrive powerhead will beep once
indicating that is ready to learn transmitter.
Within 30 seconds, press and hold the desired transmitter button(s);
LED will turn off or idrive powerhead will beep once. On the DoorMaster
only, release the transmitter and press again. LED will light briefly then
Return the emergency disconnect handle to motor operated position.
Press same transmitter button(s) again: door should operate.
Transmitter is now programmed to operate.
NOTE: idrive model only: The first transmitter command
after programming will only open the door through a six inch up/down cycle.
Normal door operation will then occur on all subsequent transmitter
Battery: If the LED (light) on the transmitter
does not turn on when a button is pressed or if the transmitter is becoming
reduced, install fresh batteries. To change the batteries, insert a coin in
the coin slot and twist to access the battery compartment. The transmitter
uses two CR2016 batteries. Install fresh batteries with the positive (+) of
the batteries facing downward into the bottom case half. Snap top case half
onto bottom case half, insuring batteries remain in their correct locations.
NOTE: The operator can be activated by
up to six remote control devices ( including) wall station and keyless entry
controls). If a seventh control is programmed, one of the programmed
controls will be overwritten and will no longer activate the operator. To
clear the programming of all remote control devices, press and hold the
DoorMaster light fixture program button, idrive, Quantum, Classic drive
status LED goes out of idrive powerhead beeps three times, then all controls
NEVER let children operate or play with door
controls. Keep remote controls away from children. Fatal injury could result
should a child become trapped between the door and the floor.
ALWAYS keep moving door in sight and away from
people and objects until it is completely closed. To prevent serious injury
or death, avoid standing in the open doorway or walking through while door