Wayne Dalton Garage Door Opener Wireless Keyless Entry System
KEYLESS ENTRY CODING INSTRUCTIONS
- With new
installations, it is recommended that the keyless entry be programmed
before mounting to wall, otherwise proceed to step B.
- Unit can be programmed
with the garage door in either up or down position.
- Press the transmitter
program button on the garage door opener to switch the opener to the
transmitter learn mode. The idrive and idrive torsion opener will remain
in the learn mode for 30 seconds. The DoorMaster opener will remain in the
learn mode for 15 seconds. The Quantum / Classic opener will remain in the
learn mode for 60 seconds.
- Push the ON/RESET
button of the keyless entry. Keypad will light indicating the unit has
been activated and is waiting for commands (illumination may be not be
visible in sunlight).
- Press the desired four
digit PIN number, the hold the “0” key until door moves. (example
1-2-3-4-0). Release “0” key. Programming is now complete.
NOTE: If, at any time, an error was
made in entering the codes, simply press the ON/RESET button and repeat the
Note: One KEP2 Keyless entry can be
programmed to open multiple garage door openers. To program fro additional
openers, repeat steps A thru E above except input a different four digit PIN
number for each additional opener.
How Your Keyless Entry Operates Your Opener:
The following explains how your keyless entry
can be used to OPEN, CLOSE, START, and STOP your door.
- Activate your keypad
by pressing the ON/RESET button; keypad will illuminate.
- Enter your 4-digit PIN
(personal identification number); door will begin to move.
NOTE: If you inadvertently enter an
incorrect code, the door will not move. Reset with the ON/RESET button and
re-enter your PIN number.
- Unit remains active
for next 15 sec. Pressing any key, except the ON/RESET, will
Stop the door if opening, or reverse the door
normal operating conditions, the battery should be changed once every 12
Dispose of used batteries properly. To Replace battery perform the.
Raise Keyless entry Cover to
expose battery door.
Snap open door with a coin and
remove old battery.
Replace battery (12 volt) with
positive terminal to right and snap close battery door.