|
MINI-TRANSMITTER MODEL 3070
Congratulations! You have
just purchases a Micro-Code Digital Transmitter, which we believe to be the
finest product of its kind on the market. With a little care this transmitter
should provide you with many years of excellent service. Please take a moment to
read the following instructions and you will find that setting your new
transmitter will be quite an easy matter.
ACCESSING
THE CODE SWITCH AND BATTERY COMPARTMENT
The
model 3070 Micro-transmitter case is composed of 2 halves which can be opened
by inserting a small coin in the slot provided. A twisting motion of the coin
will cause the 2 halves to separate. Once opened you will have access to both
the code setting switch and the battery compartment.
SELECTING
A CODE
Set both transmitter and
receiver switches to the code of your choice, being sure both are set the same
since a different setting of just one switch will prevent operation. The digital
code is determined by the position of 10 small switches numbered 1 through 10
located in the receiver and transmitter. Any combination of “on” or “off”
positions can be selected by using a pencil or ball point pen. (NOTE: The
switches are in the “on” position when the switch is depressed toward the
number.)
Once code have
been set, check operation and reassemble the transmitter case.
MICRO-TRANSMITTER INSTALLATION
This transmitter is
completely self contained, including battery and can be operated while held in
hand or while mounted in the car. It is supplied with “hook and loop” fabric for
easy mounting or it may be added to your key chain using the slot provided.
Transmitter battery
replacement
Replacement battery – 12volt
alkaline lighter battery (Eveready A 23 or equivalent)
The transmitter
battery can be checked or changed by opening the case using a small coin in the
slot provided. A twisting motion of the coin will separate the case halves and
provide access to the battery compartment. Simply slide out the old battery and
slide in the new, remembering to observe the battery polarity molded on the case
in the bottom of the battery compartment. Note that if the red L.E.D. on your
transmitter fails to light you most likely have a weak or dead battery and it
should be replaced.
OPERATIONAL
CHECK
To check
operation, move back a reasonable distance (about 50 ft) and press the
transmitter button. Operation should be reliable at this distance but
environment and location of both the transmitter and receiver will affect the
range. If the transmitter is stowed well out of sight, it may be necessary to
remove it from its mounting and hold near the windshield. Try different
locations and positions. If operation is still unsatisfactory, the problem may
be isolated by:
- Checking the door
operator. If the door will not open when the wall button is pressed, the
problem is likely to be the operator. If the door will open by pressing the
wall button, but not when the radio control button is pressed, the problem is
probably in the radios.
- Replacing the
transmitter battery. If after performing the above operational checks, the
controls still do not function, they should be returned to your dealer for
repair or replacement.
CAUTION:
Any changes or modifications in intentional or unintentional radiators which are
not expressly approved by LINEAR CORPORATION could void the user’s authority to
operate the equipment. This applies to intentional and unintentional radiators
certified per part 15 of the F.C.C. rules and regulations.
This device
complies with the FCC Part 15 and industry Canada Rules and Regulations.
Operation is subject to the following two conditions: (1) This device may cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
LINEAR CORPORATION
2055 Corte del Nogal
Carlsbad, CA 92009
| 
