|
MULTI CODE
INSTALLATION INSTRUCTIONS
DIGITAL TRANSMITTER MODEL 3089
Congratulations! You have just purchased a MULTI-CODE Digital Transmitter,
which we believe to be the finest product of it’s kind on the market. With a
little care this transmitter should provide you with many years of excellent
service. Please take a moment to read the following instructions and you will
find that setting your new transmitter will be quite an easy matter.
ASSESSING
THE CODE SWITCH
On the model 3098 the
entire front lower half of the transmitter is removable. Grasp the front lower
half of the case near the bottom on both sides and pull upward away from the
transmitter, this will disengage the lower end. Then pull downward to remove the
lower cover, this will expose both the code switch and the battery compartment.
SELECTING A CODE
You may set your
transmitter to any code you desire but be sure that the code you set matches the
code has been set on your radio receiver. The digital code is determined by the
positions of the 10 small switches numbered 1 through 10 located in the receiver
and transmitter. Any combination of ON (CLOSED) or OFF (OPEN) positions can be
selected by using a small screwdriver or ball point pen. (NOTE: The switches are
in the “On” position when the side next to the number is pressed in.) In setting
your personal code we strongly urge that several coding schemes be avoided: ALL
ON; ALL OFF; 2,4,6,8,10 ON; 1,3,5,7,9, ON. These positions are similar to our or
other manufacturer’s test positions, or are frequently used. Once the code has
been set, check the operation and replace the hatches.
TRANSMITTER
INSTALLATION
The
transmitter is completely self contained, including battery, and can be
operated while mounted in the car. It is supplied with a clip for attaching to
the sun visor, if desired. If the clip is used attach to the case by sliding it
into the recess provided on the back of the transmitter until the small dimples
fit into the holes in the clip.
TRANSMITTER BATTERY
REPLACEMENT
Replacement battery –9
volt NEDA1604 (Eveready 216 or equivalent).
The battery in the
transmitter can be checked or changed by removing the front lower half of the
transmitter. Refer to the directions under “accessing the code switch” for
battery replacement.
TO REPLACE OR ADD A SET
A replacement or
new transmitter or receiver may be purchased by specifying the model number and
the RF frequency designated on the identification label. The RF frequency is set
at the factory and must not be adjusted in the field. The digital code can be
matched to the companion receiver or transmitter by following the above
procedure.
| 
