|
|
Telectron Garage Door Opener Remote Control and Receiver Instructions
NR204AD-T80G-D RF433.9 For NEW Applications ONLY NT80G Installations Instructions This unit is designed for installation on an automobile sun visor or under the dashboard. Do not install on top of the dashboard as the sun may damage the unit. The transmitter may be operated outside or within the automobile and switch depressed only for a period of time necessary to start the door/gate. NR204AD Installation Instructions This receiver is used to control two single button electric operators, which are in close proximity or one commercial operator that has open/close capability. The 9-position dipswitch can be set to match its companion transmitter, NT80G, thereby isolating the unit from nearby units. NOTE: If you are replacing a receiver or transmitter, be sure these code match. These units operate at factory set, crystal controlled wireless frequency of 433.9MHz. If you are going to use the NR204AD receiver for anything other than the Telectron garage door operator, note that both contacts are normally open dry contacts rated to 24V. WIRING NR204AD TO A 3-BUTTON STATION Connect the white and yellow wires to the common side of the 3-button station. Connect the blue wire to the open button of the 3-button station. Connect the red wire to the close button of the 3-button station.
TROUBLESHOOTING Should you begin to experience loss of range, replace the 9volt battery. If your unit should fail to operate at all, check that the "code settings" match your receiver.
|